ExcelPTZ PTZ605 series Manual de instrucciones descargar pdf (Pagina 6)

Getting the dome up and running!

You MUST connect up the dome and your control equipment on a workbench or kitchen table before the

actual site installation and CHECK YOU KNOW HOW TO INSTALL IT CORRECTLY!!!!!!!!!!!!!!!!!.

By doing this you can set-up any DIP switches, adjust the camera, and learn about how it operates before

taking it to site. This will save you hours of time on-site trying to work out why a particular item doesn’t

function as you expected it to. There is nothing worse than installing something and then having to take it

down to see how to get it working!! Do the learning curve in the comfort of your own premises!!!!

Overview- introduction to fitting PTZ equipment

Generally speaking, PTZ Domes requires four things;

1- They require a power supply and a cable to supply this power to the dome. Often, external

domes are 24V A.C but some mini pan and tilt domes are 12V.

2- They require a cable to get the video signal back to the monitor or recording device.

3- They require a cable to transmit the “RS485 control signal” from the keypad or DVR to tell the

dome to pan, tilt and zoom etc.

4- They require something to control them, either a keypad or a DVR.

The following diagram indicates the basic cable requirements for a PTZ system.

Do you KNOW how to install PTZ equipment that is

controlled by RS485 data signals?

If not please read the following introduction to PTZ >>>… .

1 2 3 4 5 6 7 8 9 10 11 ... 57 58

Sin comentarios

ExcelPTZ PTZ605 series Manual de instrucciones Pagina 6