ExcelPTZ PTZ605 series Manual de instrucciones descargar pdf (Pagina 27)

AUTO SCAN- How to set it up

Auto-scan scans between two points. These are not presets as per the patrol(tour) facility but auto

scan selection points. You may program up to 3 auto scans.

STEP 1 – Select the required camera by pressing the <CAM> button and then entering <camera

address> on the keypad.

To setup the Auto Scan you need to enter the Menu System by selecting <CALL> 95 <Enter> or

<CALL> 64 <Enter> on the keypad.

Enter the password to enter the menu.

The Default password is 111111. See Advance Setup menu to change.

You will see the Main Menu displayed on the screen.

Using the joystick up/down direction movement, select the MOTION SETUP menu.

Use the joystick pan right movement to enter this menu.

In the AUTO SCAN menu select the scan number (maximum 3), then the speed. Now position the

camera where you wish to start scanning from. Using the joystick select SET START LIMIT. Then press the

CLOSE button to save the start position.

Now aim the camera where you wish to end the scanning point. Now select the SET END LIMIT

followed by CLOSE button to save.

Calling the Auto Scan

First you must set the start and end positions of the auto scan as above. This runs the auto scan

function between these two points. There are two methods of initiating the auto scan. If you enter

< CALL> 97 <Enter> via the keypad you can initiate the auto scan. Note that the CALL 97 will

run at the speed set in the AUTO SCAN table.

You may also initiate the auto scan through the Advanced Menu System. Enter the Main Menu by

selecting <CALL> 95 <Enter> or <CALL> 64 <Enter> on the keypad.

Enter the password to enter the menu.

The Default password is 111111. See Advance Setup menu to change.

You will see the Main Menu displayed on the screen.

Using the joystick up/down direction movement, select the MOTION SETUP menu.

Use the joystick pan right movement to enter this menu.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 57 58

Sin comentarios

ExcelPTZ PTZ605 series Manual de instrucciones Pagina 27