ExcelPTZ PTZ605 series Manual de instrucciones descargar pdf (Pagina 28)

In the AUTO SCAN menu select RUN SCAN. If the start position is the same as the end position

it will do a 360° scan. Now press the CLOSE button to save and initiate the Auto Scan.

TIP - To stop the scan just move the joystick slightly.

RECORD PATTERN- What is a record pattern

This dome has an option to store a record pattern. A record pattern consists of a continuous

sequence of standard pan and tilt movements or lens commands recorded within a 200 second

interval. A record pattern does not use presets. You can limit movement at a required position and

pan and tilt within the 200 second time restriction. Once the recording is complete, i.e you have

closed the recording or the record time has expired, you may use an option in the Motion Setup

Menu to replay the recorded pattern. Once this recorded pattern is initiated, the dome will run the

record pattern continuously until a keypad movement is detected or an alarm is activated.

RECORD PATTERN- What is the difference between a pattern & a patrol (tour)

A patrol (tour) uses presets and when initiated, the dome will move to a maximum of 16 preset

positions using the dwell times as set in the Patrol Table. The speed of dome movement between

any two presets is a constant speed and not a variable speed. A patrol (tour) can run for an extensive

length of time with a dwell time of a maximum of 99 seconds at each of sixteen preset positions. In

addition up to six different patrols (tours) can be stored each with different preset parameters

whereas only three record patterns can be recorded. When a preset is stored the dome stores not

only the preset position but also zoom and camera attributes. A record pattern does not record zoom

attributes.

A record pattern does not use presets. It however allows the user to record a continuous sequence of

standard pan and tilt movements or lens commands but does not allow presets, flip, digital zoom,

proportional pan or turbo speed. The record pattern sequence can be recorded using the keypad pan

and tilt joystick but will only record up to a 200 second interval. A record pattern allows the user a

continuous view rather than selected preset positions and is similar to an auto scan except that an

auto scan only allows a selected movement speed whereas the record pattern reflects the user

movements made during the recording of the record pattern.

RECORD PATTERN- How to set it up

Record Pattern allows a pattern to be recorded which consists of any standard pan and tilt or

lens command within a 200 second interval. A pattern is automatically closed when the 200

second interval is exceeded or by pressing the CLOSE button. Note that the following are not

allowed in a pattern: presets, flip, digital zoom, proportional pan and turbo.

STEP 1 – Select the required camera by pressing the CAM button and entering <camera address>

followed by <Enter> on the keypad.

Position the camera where you wish to start the record pattern sequence. Enter the Main Menu

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 57 58

Sin comentarios

ExcelPTZ PTZ605 series Manual de instrucciones Pagina 28